To dismount the gun, the trigger being pulled, press outward and downward on bolt stop thmnb piece, and pull out bolt to the rear, keeping thumb on end of extractor to prevent its dropping-. Push firing-pin striker out from bolt until notch on its lower end is freed from nib of cam lever and turn cam lever clear of striker ; then let go of striker. Remove cam lever, then firing-pin striker. Drive out firing-pin stop-pin, and shake firing-pin and firing-pin spring out frotn bolt. Remove collar from firing-pin striker, and take off mainspring by unscrewing to the front throug,h slot at point of striker. Unscrew trigger guard screw and receiver tang screw, and remove trigger guard. Place finger on rear end of follower, and push down until lugs are opposite clearance cut in magazine wall: spring right hand lug out through cut, and allow elevator arm to rise, turning completely over; then remove elevator arm froin its seat. Remove sear spring- and sear fly. Unscrew trigger spring screw. Remove scar and trig.„ger by driving (an pins securing diem. Take out band screws. and remove bands. Raise rear s'ght leaf to its vertical position, sight slide at top. Press barrel cover forward to clear bevel under front end of rear sight base, and remove it from barrel. Lift barrel and receiver out of stock. Press out on bolt stop thumb piece to clear stop slot, and push bolt stop down and out. Remove lock pin, located in rear of firing pin lock or tinder side of receiver, by means of notch in front side of head. Spring out checked end of bolt release, to clear stop pin from slot, and take out bolt release. Push firing-pin lock down until lug at its lower end clears guide ; then turn it outward, and remove through slot in frame of receiver. To assemble the
gun, enter the firing-pin-lock through slot in side of receiver, and turn it up, and in, until lug at its lower end clears guide; then press it up into place. Pitt in bolt release and spring it into position. Force in lock pin, with lug bearing against firing-pin-lock. Enter bolt stop and slide it into place. Place barrel and receiver in stock. Put on barrel cover and bands, and screw in band screws. Place sear, trigger, and trigger spring in trigger guard. securing them by their pins and screw. Enter sear fly in its seat on sear, and put in sear soring. Place elevator arm in its seat, follower clown, engaging hole in elevator spring with pin ; swing elevator arm over, holding point of follower up, and push lug through clearance cut; then allow elevator arm to rise into place. Place trigger guard in stock, and screw in trigger guard ecrew and receiver tang screw. Enter square end of mainspring into slot at point of firing-pin striker and screw it on. Put collar on firing-pin striker so that square end of mainspring rests in notch on its front end. Place firing-pi spring on firing-pin and enter them into bolt, securing firing-pin by stop-pin. Put firing-pin striker in bolt, and enter cam-lever in its seat. Turn handle of cam-lever back until nib engages notch on firing-pin striker. Hold rear end of extractor against small lug on left side of bolt ; then enter bolt and extractor into receiver. Put up bolt stop and thumb piece to lock bolt in receiver. See Winchester Arms.